The wireless keypad entry allows you to open your garage door by punching in a 4 digit PIN or personal identification number on the 10 key keypad that you can attach to most surfaces in any location on your home that you desire some homeowners like to put them in conspicuous places and some just put them outside right next to the garage door. You can use Marantect wireless keypads for up to 4 opener units with 4 different PIN numbers. If the keypad is on the outside of home they are made to withstand the elements.

First step

The first step is to make sure batteries are still good. If you push buttons and LED lights don’t light up the batteries are bad.

Replacing batteries is pretty easy just unscrew screws on back of keypad and pull the old batteries out and take them to a store and match the numbers on the flat round watch type batteries. Once new batteries are installed you can proceed with programming keypad. Also you will need your remote to program keypad.

Second step

Second step is to hold down the 3 button until you see the LED light up, this means its ready. Hold your remote close to the bottom of the keypad somewhere near the 8 and 9 buttons the hold down on remote button that opens up your door until the LED on the keypad starts to flash then release remote button. Next input a four digit PIN and never use your address its the first code a thief will attempt. After pin is entered press enter button and LED light will light up for two seconds or so letting you know programming is complete. You will have to duplicate these steps for multiple code for other opener units you may have. Remember each button on your remotes will need a different PIN 4 maximum PIN’s.