Troubleshooting One-Piece Garage Door Issues

Common Problems with One-Piece Garage Doors

Q: My one-piece garage door rubs the side of my door jambs when it is going up and down, and it looks ugly because it is rubbing off the paint. Can that be fixed?

Understanding the Cause of Rubbing

A: Several reasons could cause a one-piece garage door to rub against the side of the door jamb. One possibility is that there isn’t enough of a gap on both the left and right sides of the garage door. Optimal spacing should be about an inch. When the spacing narrows to less than an inch, the door tends to rock left and right as it closes, leading to rubbing against the door jamb.

Assessing Door Jamb Spacing

If sufficient space exists on both sides of the garage door, the issue may stem from the hinges that open and close the door. Over time, hinges can weaken or deteriorate, diminishing their ability to hold the weight of a wooden one-piece garage door.

Checking and Replacing Hinges

In most cases, the hinges are at fault, especially if they show significant wear and tear due to age. Replacing the hinges should effectively resolve the problem of the door rubbing against the door jamb.

The Importance of Regular Maintenance

To prevent issues like this in the future, regular maintenance of your garage door is essential. Checking the spacing and condition of both the door and its components will keep your garage door functioning smoothly and looking good.

Conclusion: Fixing Your Garage Door

In conclusion, if your one-piece garage door is rubbing against the jambs, assessing the spacing and the hinges is key to identifying the problem. Implementing these fixes will not only improve the functionality of your garage door but also enhance your home’s curb appeal.

Frequently Asked Questions

om good

We receive many calls involving the safety eyes preventing the garage door from closing due to the safety eyes malfunctioning or simply being out of alignment. If your garage door opens fine, but will not close using the wall console, then this could be a safety eye issue. If the opener light flashes and/or the motor makes a clicking sound, this is a warning that you have a safety eye issue. You can begin by looking at the safety eyes themselves. You should see a steady light on both of the safety eyes. If one of the lights is flashing then you may just need to simply align the eyes properly. This is done by physically moving/adjusting the safety eyes until you have both safety eyes with a solid light showing.

If both safety eyes are showing a solid light, then you may have malfunctioning safety eyes.

A simple test is to press and hold the wall console to close the door. If the garage door closes while holding the wall console button, then you probably have a safety eye issue. 

We offer a full line of commercial garage door openers to fit the needs of the customer. For smaller commercial sectional garage doors we recommend using the Liftmaster 8900W these operators are rated for 14 feet maximum height and 300lbs total weight. For rolling steel doors we recommend the 8950W for doors up to 12 feet maximum height and maximum weight of 850lbs.

For large sectional commercial doors we recommend the Liftmaster J or H. These are equipped with MyQ for automated opener control and are equipped with a soft start/stop feature.

The Liftmaster J, jackshaft opener is available in ⅓, ½, ¾ and 1 horse power. The horse power needed is based on the total square footage of the sectional door it will be installed on.

Ask a question?

If you have a questioin regarding a part , fill your details and  we will get back to you shortly.

Ask a question?

If you have a questioin regarding a part , fill your details and  we will get back to you shortly.